Datalogger Plus: the best ally for each professional tuner Configure your Datalogger Check the compatibility on the vehicle list so select the needed vehicle. Connect the OBDII cable (FLX2.10) and go through the steps of the checklist to carry out a perfect test. Choose the most suitable sensors and values for your analysis, configure their display and jump on the car to make your record. Choose the most suitable parameters The right amount of parameters that could be analyzed depends on the selected model of vehicle, ranging between 50 and 2000 switchable sensors. To minimize configuration times of the most suitable sensors, the software automatically groups the most commonly used parameters in default mode. This significantly saves the user's time and guarantees an intuitive and fast search. Each sensor can be displayed in 5 different modes: graph, numerical value, linear gauge, large gauge and small gauge. Data sampling up to 50Hz in Plus mode The Plus version allows you to record with sampling up to 50Hz. It is possible to share and view your data from any device, when connected to the ECUs, witch adapts automatically on the base of the number of sensors selected by the user. This is to offer maximum efficiency in all conditions and with a sampling rate of up to 20ms. Share and view data directly from the online panel Use the online chart to view and analyze the recording once the test is finished. Share measurements with other users at any time. By clicking on the share button the share link will be generated. The online chart is compatible with any kind of desktop and portable device.

OBD/BENCH ECUS (CARS, BIKES, VANS) SLAVE On activation of this SW package for FLEX, the user may work on all supported protocols for ECUs in cars, motorcycles and vans in OBD and Bench mode. Thanks to the state-of-the-art FLEX HW, programming in Bench mode guarantees a complete reading and writing of the contents of the control unit with no need to open it.