Datalogger Plus: the best ally for each professional tuner Configure your Datalogger Check the compatibility on the vehicle list so select the needed vehicle. Connect the OBDII cable (FLX2.10) and go through the steps of the checklist to carry out a perfect test. Choose the most suitable sensors and values for your analysis, configure their display and jump on the car to make your record. Choose the most suitable parameters The right amount of parameters that could be analyzed depends on the selected model of vehicle, ranging between 50 and 2000 switchable sensors. To minimize configuration times of the most suitable sensors, the software automatically groups the most commonly used parameters in default mode. This significantly saves the user's time and guarantees an intuitive and fast search. Each sensor can be displayed in 5 different modes: graph, numerical value, linear gauge, large gauge and small gauge. Data sampling up to 50Hz in Plus mode The Plus version allows you to record with sampling up to 50Hz. It is possible to share and view your data from any device, when connected to the ECUs, witch adapts automatically on the base of the number of sensors selected by the user. This is to offer maximum efficiency in all conditions and with a sampling rate of up to 20ms. Share and view data directly from the online panel Use the online chart to view and analyze the recording once the test is finished. Share measurements with other users at any time. By clicking on the share button the share link will be generated. The online chart is compatible with any kind of desktop and portable device.

SW FLEX NEC 76F00XX SLAVE This software package includes protocols for work in JTAG AUD on engine control units that mount NEC76F00xx microprocessors. This family of microprocessors can be found in Toyota Denso 275xxx or 175xxx engine control units. This SW package makes it possible to communicate with the supported units through the JTAG port so in this case, it is necessary to open the control unit.

SW FLEX TCU OBD + BENCH + BOOT MASTER With this FLEX SW package, the user may work on all supported protocols for TCUs in OBD, Boot and Bench mode. In Bench mode, as in the case of ECUs, FLEX is able to give a complete reading and writing of the content.